Brightness

Setting the brightness

To set the brightness of the Control Display:

1. "Settings"

2. "Control display"

3. "Brightness"

Brightness"
Brightness"

4. Turn the controller until the desired brightness is set.

5. Press the controller.

The setting is stored for the remote control currently in use.

Depending on the light conditions, the brightness control may not be clearly visible.

    See also:

    Preparation
    1. Check whether the battery of the other vehicle has a voltage of 12 volts. This information can be found on the battery. 2. Switch off the engine of the assisting vehicle. 3. Switch off any el ...

    Display
    Night Vision with pedestrian detection is not available on the rear screen. Adjustments via the iDrive With Night Vision switched on: 1. Activate Night Vision with pedestrian detection. 2. Press ...

    TeleService
    General information TeleService supports communication with your service center. ► Data on the vehicle's service requirements can be sent directly to the service center. In this way, the ...