What to do if...
► The current transmission position cannot be displayed? The vehicle is located in an unrecognized region, is in a poor reception area, or the system is currently determining the position.
Reception is usually best when you have an unobstructed view of the sky.
► The destination without street information is not used for route guidance? When city has been input, no downtown can be determined.
Input any street in the selected city and start destination guidance.
► The destination is not used for route guidance? The destination data is not contained in the navigation data. Select a destination that is as close as possible to the original.
► Letters for destination input cannot be selected? The stored data do not contain the data of the destination.
Select a goal that is as close as possible to the original.
► Is the map displayed in shades of gray? "Traffic conditions/gray map" Active: indication on the control display is switched to shades of gray. This enables a better view of the traffic bulletins.
► Spoken instructions are no longer output during route guidance in front of intersections? The area has not yet been fully recorded, or you have left the recommended route and the system requires a few seconds to calculate a new route suggestion.
See also:
Radar sensor
Position
Radar sensor
Dirty or covered sensor
A dirty or covered sensor may hinder the detection
of vehicles.
If necessary, clean the radar sensor. Remove
layers of snow and ice carefull ...
Load
BMW X5:
BMW X5
BMW X6:
BMW X6
The maximum load is the sum of the weight of
the occupants and the cargo.
The greater the weight of the occupants, the
less cargo that can be transported. ...
Headlamps
▷ Do not rub dry and do not use abrasive or
caustic cleansers.
▷ Soak areas that have been soiled e.g. due to
insects, with shampoo and wash off with
water.
▷ Thaw ice with d ...