Tail lamps, bulb replacement
At a glance
1. Turn signal
2. Reversing lamp
3. Inside brake lamp
4. Tail lamp
5. Outside brake lamp
6. Rear reflector
Turn signal, outer brake, tail, and license plate lamps
Follow the general instructions on lamps and bulbs
These lights are made using LED technology.
Contact your service center in the event of a malfunction
Lamps in the trunk lid
Access to the lamps
1. Remove the three screws using the screw driver from the onboard vehicle tool kit.
2. Fold away the cover.
Inside brake lamp
Follow the general instructions on lamps and bulbs
21-watt bulb, H21W
The illustration shows the position of the bulb in the installed bulb holder
Squeeze the clips together and remove the bulb holder.
Press the bulb into the bulb holder, turn counterclockwise and remove.
Reversing lamp
Follow the general instructions on lamps and bulbs
16-watt bulb, W16W
The illustration shows the position of the bulb in the installed bulb holder.
Squeeze the clips together and remove the bulb holder.
Pull out the bulb and replace it.
See also:
Using the door lock
General information
Locking from the outside
Do not lock the vehicle from the outside if
there are people in it, as the vehicle cannot be
unlocked from inside without special knowledge.
The ...
Drive away without delay
Do not wait for the engine to warm up while the
vehicle remains stationary. Start driving right
away, but at moderate engine speeds.
This is the fastest way for the cold engine to
reach its ope ...
Malfunctions
Steering wheel vibration
Frequent activation of the steering wheel vibration
causes the system to overheat.
This causes the lane departure warning to become
deactivated.
Let the system cool and ...