What to do if...
▷ The current transmission position cannot be displayed?
The vehicle is located in an unrecognized region, is in a poor reception area, or the system is currently determining the position.
Reception is usually best when you have an unobstructed view of the sky.
▷ The destination without street information is not used for route guidance?
When city has been input, no downtown can be determined.
Input any street in the selected city and start destination guidance.
▷ The destination is not used for route guidance?
The destination data is not contained in the navigation data. Select a destination that is as close as possible to the original.
▷ Letters for destination input cannot be selected?
The stored data do not contain the data of the destination.
Select a goal that is as close as possible to the original.
▷ Is the map displayed in shades of gray?
"Traffic conditions/gray map" Active: indication on the control display is switched to shades of gray. This enables a better view of the traffic bulletins.
▷ Spoken instructions are no longer output during route guidance in front of intersections?
The area has not yet been fully recorded, or you have left the recommended route and the system requires a few seconds to calculate a new route suggestion.
See also:
Reverse gear
Select only when the vehicle is stationary. When
the gearshift lever is pressed to the left, a slight
resistance needs to be overcome. ...
Adaptive light control
The concept
Adaptive light control is a variable headlamp
control system that enables dynamic illumination
of the road surface.
Depending on the steering angle and other parameters,
the light ...
Transmission positions
D Drive, automatic position
Position for normal vehicle operation. All forward
gears are available.
R is Reverse
Select only when the vehicle is stationary.
N is Neutral
Use in automatic car wa ...
