Manual destination entry

General information

The system supports you in entering street names and house numbers by automatically completing the entry and providing entry comparisons.

Stored town/city and street names can be called up quickly.

▷ If the existing entries should not be changed, the entries for the state/province and town/ city can be skipped.

▷ Destination guidance is started to the town/ city center if no street is entered.

Entering a state/province

1. "Navigation"
2. "Enter address"

3. Select "State/Province" or the displayed

3. Select "State/Province" or the displayed state/province.

Entering a town/city

1. Select "Town/City/Postal Code" or the displayed town/city.

2. Select letters, if necessary.

2. Select letters, if necessary.
The list is narrowed down further with each entry.
3. Move the controller to the right.
4. Select the town/city name from the list.
If there are several towns/cities with the same name:
1. Change to the list of town/city names.
2. Highlight the town/city.
3. Select the town/city.

Entering the postal code

1. Select "Town/City/Postal Code" or the displayed town/city.
2. 3. Select the numbers. Select the symbol.
3. Select the numbers.
4. Change to the list of postal codes and towns/ cities.
5. Highlight the entry.
6. Selecting an entry.

Entering a street and intersection

1. Select "Street" or the displayed street.
2. Enter a street and intersection in the same way as you would enter a town/city.
If there are several streets with the same name:
1. Change to the list of street names.
2. Highlight the street.
3. Select the street.

Alternative: enter the street address and house number

1. Select "Street" or the displayed street.
2. Enter the street as you would the town/city.
3. "House number".
4. Select the numbers.
5. Change to the list of house numbers.
6. Select a house number or range of house numbers.

Street does not exist in the destination city/town

The desired street does not exist in the specified city/town because it belongs to another part of the city/town.

1. "Navigation".
2. "Enter address".
3. Select "Street" or the displayed street.
4. Change to the list of street names.
5. Select "In" the displayed country.
All streets of the selected state/province are offered. The associated town/city is displayed after the street name.

6. Select the letters.

6. Select the letters.
7. Change to the list of street names.
8. Highlight the street.
9. Select the street.

Starting destination guidance after entering the destination

1. "Accept destination".
2. "Start guidance" or "Add as another destination"
Add, a destination as a further destination.

    See also:

    Removing the remote control from the ignition lock
    Do not forcibly pull the remote control out of the ignition lock Do not forcibly pull the remote control out of the ignition lock as this may cause damage.◀ Before removing the remote c ...

    Setting the clock
    1. Press the button. The main menu is displayed. 2. Turn the controller until "Settings" is highlighted, and then press the controller. 3. If necessary, move the controller to ...

    Programming
    Programming 1. Memory buttons 2. LED Fixed-code hand-held transmitters 1. Switch on the ignition, refer to page 61. 2. Initial setup: Press both outer memory buttons 1 for approx. 20 seconds ...