Display on the Control Display
Switching on the backup camera via iDrive
With PDC activated:
"Rear view camera"
The backup camera image is displayed. The setting is stored for the remote control currently in use.
Brightness
With the backup camera switched on:
1. 
Select the symbol.
2. Turn the controller until the desired setting is reached and press the controller.
Contrast
With the backup camera switched on:
1. 
Select the symbol.
2. Turn the controller until the desired setting is reached and press the controller.
See also:
Functional requirements
The system must have been reset while the inflation
pressure was correct; otherwise, reliable
signaling of a flat tire is not ensured.
Always use wheels with TPM electronics to ensure
that the ...
General information
Two different driver's seat and exterior mirror
positions can be stored and retrieved for each
remote control. Settings for the backrest width
and lumbar support are not stored in memory. ...
Configuring the prewarning
After the warning function is switched on, the
following can be set via the iDrive:
▷ The prewarning can be switched on/off.
▷ The time of the prewarning can be set.
These settings ha ...