Initializing after a power failure
After a power failure during the opening or closing process, the roof can only be operated to a limited extent.
Initializing the system
The system can be initialized when the vehicle is stationary and the engine is running.
During the initialization, the roof closes without pinch protection.
Danger of pinching
Monitor the closing process and make sure that the closing path of the glass sunroof is clear; otherwise, injuries may result.
Press the switch up and hold it until the initialization is complete:
▷ Initialization begins within 15 seconds and is completed when the sunroof is completely closed.
▷ The roof closes without pinch protection.
See also:
Functional requirements
The system must have been reset while the inflation
pressure was correct; otherwise, reliable
signaling of a flat tire is not ensured.
Always use wheels with TPM electronics to ensure
that the ...
Radar sensors
The radar sensors are located under the rear
bumper.
The system may not be fully functional in the
following situations:
Dirty or icy bumper.
Stickers on the bumper.
A Check Control me ...
New remote controls
You can obtain new remote controls from your
service center. ...