Storing a channel
1. "Radio"
2. "Satellite radio"
3. If necessary, open "All channels" or the desired category.
4. Select the desired channel.
5. Press the controller again.
6. Press the controller again to confirm the highlighted channel.
Press the controller again to confirm the
highlighted channel
7. Select the desired memory location.
The channels are stored for the remote control currently in use.
The channels can also be stored on the programmable memory buttons
See also:
Functional requirements
The system must have been reset when the inflation
pressure was correct; otherwise, reliable
signaling of a flat tire is not ensured. Always use
wheels with TPM electronics to ensure that the
...
Jacking points for the vehicle jack
Jacking points for the vehicle jack
The jacking points for the vehicle jack are located
in the positions shown. ...
What to do if...
► The current transmission position cannot be
displayed?
The vehicle is located in an unrecognized
region, is in a poor reception area, or the
system is currently determining the position.
...