Calibrating the digital compass
The digital compass must be calibrated in the following situations:
▷ An incorrect compass direction is shown.
The cardinal direction displayed does not
change even if the direction of travel
changes.
▷ Not all compass directions are shown.
Procedure
1. Make sure that there are no large metal objects or overhead power lines in the vicinity of the vehicle and that there is enough space to drive in a circle.
2. Set the currently valid compass zone.
3. Press the adjustment button for 6‑7 seconds to call up C. Then drive at least one full circle at a maximum speed of 4 mph/7 km/h.
When the system is calibrated, the C is replaced by the compass directions.
See also:
Specifying the street
If the system does not recognize the street, one
of the following pieces of information is displayed:
▷ A street name in the vicinity.
▷ The county.
▷ The coordinates of the des ...
Integrated key
Integrated key
Press the button on the back of the remote control,
arrow 1, and pull out the key, arrow 2.
The integrated key fits the following locks:
▷ Driver's door.
▷ Glove com ...
General information
Two different driver's seat and exterior mirror
positions can be stored and retrieved for each
remote control. Settings for the backrest width
and lumbar support are not stored in memory. ...