Reassigning individual programs
1. Switch on the ignition.
2. Hold the hand-held transmitter at a distance of approx. 1 to 3 in/2.5 to 8 cm from the memory buttons.
The required distance depends on the particular hand-held transmitter.
3. Press the memory button of the integrated universal remote control.
4. If the LED flashes slowly after approx.
20 seconds, press the transmit button on the hand-held transmitter.
5. Release both buttons when the LED flashes rapidly.
If the LED does not flash rapidly after approx.
60 seconds, change the distance and repeat the step.
Canada: if the LED does not flash rapidly after approx. 60 seconds, change the distance and repeat the step. If programming was aborted by the hand-held transmitter, hold down the memory button and press and release the button on the hand-held transmitter several times for 2 seconds.
See also:
New wheels and tires
Have new wheels and tires installed only by
your BMW center or tire shop that works according to BMW repair procedures with
correspondingly trained personnel. If this work is not carried out prop ...
General information
Instructions for voice activation system, refer to
page 22.
To have the available spoken instructions read
out loud: ›Voice commands‹ ...
Steptronic
In addition to fully automatic operation, you can also manually shift with the
Steptronic.
Vehicle parking To prevent the vehicle from rolling, always
select position P and apply the parking brak ...