Residual heat

The heat stored in the engine is used to heat the interior.

Functional requirement

▷ Up to 15 minutes after the engine has been switched off.
▷ Warm engine.
▷ The battery is sufficiently charged.
▷ External temperature below 77 ℉/25 ℃.

Switching on

1. Switch off the ignition.

2. Press the right-hand button.

the automatic REST appears on the display of the automatic climate control when the residual heat utilization is switched on.

From radio readiness the interior temperature, the air volume and the air distribution can be set.

Switching off

You can select the lowest blower speed by pressing and holding the left side. Pressing again switches off the residual heat utilization.

REST disappears from the display of the automatic climate control.

    See also:

    Communications
    This chapter describes how to use the telephone, BMW Assist and BMW TeleServices. ...

    Calibrating the digital compass
    The digital compass must be calibrated in the following situations: ▷ An incorrect compass direction is shown. The cardinal direction displayed does not change even if the direction of tra ...

    Indication of a flat tire
    The yellow warning lamp lights up. A Check Control message is displayed. There is a flat tire or a major loss in tire inflation pressure. 1. Reduce your speed and stop cautiously. Avoid sudd ...