Image on the Control Display

Switching on the rear view camera using iDrive

With PDC activated:

The image of the rear view camera is displayed. "Rear view camera" The image of the rear view camera is displayed.

The setting is stored for the remote control currently in use.

Brightness

With the rear view camera switched on:

1. 2. Turn the controller until the desired setting Select the symbol.

2. Turn the controller until the desired setting is reached and press the controller.

Contrast

With the rear view camera switched on:

1. symbol. Select the symbol.

2. Turn the controller until the desired setting is reached and press the controller.

    See also:

    TeleService
    General information TeleService supports communication with your service center. ▷ Data on the vehicle's service requirements can be sent directly to the service center. In this way, the ...

    Preparation
    1. Check whether the battery of the other vehicle has a voltage of 12 volts and approximately the same capacitance in Ah. This information can be found on the battery. 2. Switch off the engine ...

    Cargo loading
    To avoid loading the tires beyond their approved carrying capacity, never overload the vehicle. Overloading can lead to overheating and increases the rate at which damage develops inside the tire ...