Resetting the system
Reset the system after each correction of the tire inflation pressure and after every tire or wheel change.
1. "Vehicle Info"
2. "Vehicle status"
3.
"Reset"
4. Start the engine - do not drive away.
5. Reset the tire pressure using "Reset".
6. Drive away.
The tires are shown in gray and "Resetting TPM..." is displayed.
After driving for a few minutes, the set tire inflation pressures are applied as set values. The resetting process is completed automatically as you drive. The tires are shown in green and "TPM active" is shown on the Control Display.
The trip can be interrupted at any time. If you drive away again, the process resumes automatically.
Do not reset the system when driving with a compact wheel.
If a flat tire is detected while the system is resetting, all tires on the Control Display are displayed in yellow. The message "Low tire!" is shown.
See also:
Tire tread
Summer tires
Do not drive with a tire tread depth of less than
0.12 in/3 mm.
There is an increased danger of hydroplaning if
the tread depth is less than 0.12 in/3 mm.
Winter tires
Do not driv ...
Planning a trip with intermediate
destinations
New trip
A trip can be planned with several intermediate
destinations.
1. "Navigation"
2. "Map"
3. Move the controller to the left if necessary.
4. "Guidance"
5. ...
Traffic Jump
Traffic and weather information for a selected region is broadcast every few
minutes.
Selecting a region1. "Radio"
2. "Satellite radio"
3. Open "Options ...
