Initialization

The initialization process adopts the set inflation tire pressures as reference values for the detection of a flat tire. Initialization is started by confirming the inflation pressures.

Do not initialize the system when driving with snow chains or with a compact wheel.

1. "Vehicle Info"

2. "Vehicle status"

3. 4. Start the engine - do not drive away. "Reset"

4. Start the engine - do not drive away.

5. Start the initialization with "Reset".

6. Drive away.

The initialization is completed while driving, which can be interrupted at any time.

The initialization automatically continues when driving resumes.

    See also:

    Deactivating DSC: DSC OFF
    When DSC is deactivated, driving stability is reduced during acceleration and when driving in bends. Stabilizing interventions by the Integral Active Steering system are only performed by the r ...

    Switching off automatically
    The system switches off and the LED goes out: After approx. 160 ft/50 m when driving forward. Above approx. 22 mph/36 km/h when driving forward. Switch on the system again if necessary. ...

    Tire damage
    General information Inspect your tires often for damage, foreign objects lodged in the tread, and tread wear. Notes Driving over rough or damaged road surfaces, as well as debris, curbs and oth ...