Putting into operation after a power failure
Putting the parking brake into operation
The parking brake should only be put into
operation again if it was manually released due
to an interruption in the supply of electrical
power. Otherwise the operation of the parking
brake is not ensured and there is a danger of the
vehicle rolling despite the parking brake being
set.◀
Procedure
1. Switch on the ignition.
2. Press the button with the brake depressed.
The indicator lamp in the
instrument
cluster goes out as soon as the parking
brake is ready for operation.
Indicator lamp in Canadian
models.
Any noises which occur are normal. Startup may take several seconds.
See also:
General information
Refuel promptly
Refuel no later than at a range of 30 miles/50 km, or operation of the engine is
not ensured and damage may occur.◄ ...
Indicator/warning lamps
The indicator and warning lamps can light up in
a variety of combinations and colors.
Several of the lamps are checked for proper
functioning and light up temporarily when the
engine is start ...
Office information
The number of unread messages and active
tasks as well as the upcoming appointments are
displayed.
1. "Office"
2. "Current office"
3. Select the desired entry to display det ...
