Initialization after a power failure

After a power failure, it is only possible to raise the roof, if necessary.

Have the system initialized by your service center.

    See also:

    Programming
    Programming 1. Memory buttons 2. LED Fixed-code hand-held transmitters 1. Switch on the ignition, refer to page 61. 2. Initial setup: Press both outer memory buttons 1 for approx. 20 seconds ...

    Requirements
    Via the Control Display, set a language that is also supported by the voice activation system so that the spoken commands can be identified. Set the language. ...

    Avoiding unintentional alarms
    The tilt alarm sensor and interior motion sensor can be switched off together, such as in the following situations: ▷ In automatic car washes. ▷ In duplex garages. ▷ During tr ...