Radio Data System RDS
In the FM waveband, additional information is transmitted via RDS. If the reception conditions are good, the station names are shown on the Control Display. Where reception is poor or in the event of interference, it may take some time before the station names appear in the display.
Switching the RDS on/off
1. "Radio"
2. "FM"
3. Open "Options".
4. "RDS"
The setting is stored for the remote control currently in use.
See also:
Configuring the prewarning
After the warning function is switched on, the
following can be set via the iDrive:
▷ The prewarning can be switched on/off.
▷ The time of the prewarning can be set.
These settings ha ...
Preparation
1. Check whether the battery of the other vehicle
has a voltage of 12 volts. This information
can be found on the battery.
2. Switch off the engine of the assisting vehicle.
3. Switch off any el ...
Switching off
The system can be deactivated as follows:
▷ Press the button.
▷ Switch off the ignition. ...