Parked car ventilation

The concept

The parked car ventilation provides ventilation to the passenger compartment and lowers its temperature, if necessary.

The parked car ventilation system is operated via iDrive. Two different switch-on times can be preselected.

The parked car ventilation remains switched on for approx. 30 minutes. The system can also be switched on and off directly. Due to its high power consumption, it should not be switched on twice in a row without driving in between to allow the battery to recharge.

The parked car ventilation system comes on if the outside temperature is above 59 7/15 6 when the switch-on time was preselected, but is ready for use at any temperature when the system is switched on directly.

The air emerges from the air vents for the upper body area in the instrument panel. The air vents must therefore be open.

Switching on and off directly

1.  "Settings"
2.  "Climate"

3.  "Activate parked-car vent."

3.  "Activate parked-car vent."

flashes. The symbol on the automatic climate control display flashes.

Preselecting switch-on times

1.  "Settings"
2.  "Climate"
3.  "Activate Timer 1" or "Activate Timer 2"
4.  "Timer 1:" or "Timer 2:"

5.  Turn the controller: set the hours.

5.  Turn the controller: set the hours.
6.  Press the controller: the setting is accepted.
7.  Turn the controller: set the minutes.
8.  Press the controller: the setting is accepted.

Display lights up. The symbol on the automatic climate Control

Display lights up.

flashes when the system has switched on. The symbol on the automatic climate Control Display flashes when the system has switched on.

next 24 hours only. After these have elapsed, it must be reactivated. The respective system is switched on within the next 24 hours only. After these have elapsed, it must be reactivated.

    See also:

    Width, height
    Width, height 1 Vehicle height without roof-mounted aerial: 56.3 inches/1,430 mm Vehicle height with roof-mounted aerial: 56.7 inches/1,442 mm 2 Vehicle width, without mirrors: 71.3 inches/1,811 ...

    Switching the warning function on/off
    Press the button ▷ On: the LED lights up. ▷ Off: the LED goes out. The state is stored for the remote control currently in use. ...

    Damage to safety belts
    In the case of strain caused by accidents or damage: Have the safety belts, including the safety belt tensioners, replaced and have the belt anchors checked. Checking and replacing safety b ...