Display
Language on the Control Display
Setting the language
1. "Settings"
2. "Language/Units"
3. "Language:"
4. Select the desired language.
The setting is stored for the remote control currently in use.
Setting the voice dialog
Switch between a standard dialog and a short dialog.
1. "Settings"
2. "Language/Units"
3. "Speech mode:"
4. Select the desired dialog.
The setting is stored for the remote control currently in use.
Brightness of the Control DisplayThe brightness is automatically adapted to the ambient lighting conditions. However, you can change the basic setting.
1. "Settings"
2. "Control display"
3. "Brightness"
4. Turn the controller until the desired setting is selected.
5. Press the controller.
The setting is stored for the remote control currently in use. In bright conditions, for example, the brightness control may not be clearly visible.
See also:
Low tire pressure message
The yellow warning lamp lights up. A
Check Control message is displayed.
There is a flat tire or a major loss in
tire inflation pressure.
The system was not reset after a wheel
change ...
Use coasting conditions
When approaching a red light, take your foot off
the accelerator and let the vehicle coast to a halt.
On a downhill gradient, take your foot off the accelerator
and let the vehicle roll.
The flo ...
Condition Based Service CBS
Sensors and special algorithms take into account
the driving conditions of your vehicle.
Based on this, Condition Based Service determines
the maintenance requirements.
The system makes it pos ...