Date
The settings are stored for the remote control currently in use, refer also to Personal Profile on page 28.
Setting the dateIn the instrument cluster
To set the dd/mm or mm/dd date format, refer to Setting the date format below.
1. Push button 1in the turn signal/high beam lever up or down repeatedly
until the appropriate symbol appears in the display, accompanied by the date and
the word "SET".
2. Press button 2.
3. Use button 1to set the day of the month.
4. Press button 2to confirm the entry.
5. Set the month and the year in the same way.
6. Press button 2.
The system stores the new date.
Via iDrive
1. "Settings"
2. "Time/Date"
3. "Date:"
4. Turn the controller until the desired day is displayed, and press the controller.
5. Create the necessary settings for the month and year.
The date is stored.
Setting the date format1. "Settings"
2. "Time/Date"
3. "Format:"
4. Select the desired format. The date format is stored.
See also:
Preparation
1. Check whether the battery of the other vehicle
has a voltage of 12 volts and approximately
the same capacitance in Ah. This information
can be found on the battery.
2. Switch off the engine ...
Rear
In the center armrest.
Pull the center armrest forward at the strap.
To open: press the button.
To close: push both covers back in, one after the
other.
Pushing back the covers
Push back the ...
Condition Based Service CBS
Sensors and special algorithms take into account
the driving conditions of your vehicle.
Based on this, Condition Based Service determines
the maintenance requirements.
The system makes it possi ...