Coupe: glass roof, electric
To prevent injuries, watch the glass roof while
closing it.
Take the remote control with you when you leave the car; otherwise, children could operate the roof and possibly injure themselves.
Press the switch.
> The closed glass roof is tilted and the sliding visor opens slightly.
Do not close the sliding visor forcibly with
the roof in the tilted position, as this would damage the mechanism.
> Press the switch backwards to the resistance point.
The glass roof and the sliding visor open together as long as you hold the switch in this position.
> Press the switch backwards past the resistance point.
The glass roof and the sliding visor open
automatically. Briefly press the switch again to stop the opening movement.
You can close the glass roof in a similar manner by pressing the switch forwards. The sliding visor remains open and can be closed by hand.
For information on Convenient opening and closing via the remote control or the door lock, or 32. For information on Convenient closing with Comfort Access, refer to Locking on page 36.
After switching off the ignition
When the remote control is removed or the ignition is switched off, you can still operate the roof for approx. 1 minute as long as no door has been opened.
Pinch protection systemIf the glass roof encounters an obstruction during closing from approximately the middle of the opening in the roof, or during closing from the tilted position, the closing movement is interrupted and the glass roof is opened again slightly.
Despite the pinch protection system check and
clear the roof's travel path prior to closing it; otherwise, the safety system might
fail to detect certain kinds of obstructions, such as very thin objects, and the
roof would continue closing.
Closing without pinch protection
If there is an external danger, press the switch forward past the resistance point and hold it there. The roof closes without pinch protection.
Following interruptions in electrical power supply
After a power failure, there is a possibility that the glass roof can only be tilted. The system must be initialized. BMW recommends having this work done by your BMW center.
Closing manuallyIn the event of an electrical malfunction, you can move the glass roof manually:
1. Unclip the front of the cover of the interior lamps using the screwdriver from the onboard vehicle tool kit.
2. On both sides, use the screwdriver to press on the clip inside the opening.
3. Remove the control unit.
4. Unplug the motor. Considerably less effort will be required for manual
operation.
5. Insert the Allen wrenchsupplied with the onboard vehicle tool kit, , into the opening provided. Move the glass roof in the desired direction.
6. Reattach the lamp cover and reinstall the control unit.
See also:
Front airbags
Front airbags help protect the driver and front
passenger by responding to frontal impacts in
which safety belts alone cannot provide adequate
restraint. ...
Compact wheel
Safety precautions in the event of a flat tire
or wheel change
Park the vehicle as far as possible from passing
traffic and on solid ground. Switch on the hazard
warning system.
Set the park ...
Contacts
Note
If equipped with full mobile phone preparation
package.
At a glance
Contacts can be created and edited. The contacts
from the mobile phone are displayed as
well if this function is suppo ...