Arming and disarming the alarm system

When you lock or unlock the vehicle, either with the remote control or at the door lock, the alarm system is armed or disarmed at the same time.

Door lock and armed alarm system

Unlocking via the door lock will trigger the alarm on some market-specific versions.

This alarm can only be ended by pressing the button on the remote control.

Tailgate and armed alarm system

The tailgate can be opened using the remote control, even if the alarm system is armed.

control. Press the button on the remote control.

After the tailgate is closed, it is locked and monitored again by the alarm system. The hazard warning system flashes once.

In some market-specific versions, the tailgate can only be opened using the remote control if the vehicle was unlocked first.

Switching off the alarm

▷ Unlock the vehicle using the remote control
▷ Insert the remote control all the way into the ignition lock.

Indicator lamp on the interior rearview mirror

Indicator lamp on the interior rearview
Indicator lamp on the interior rearview mirror

▷ The indicator lamp flashes continuously:
The system is armed.

▷ The indicator lamp flashes after locking:
The doors, hood or tailgate is not closed properly, but the rest of the vehicle is secured.
The indicator lamp flashes continuously after approx. 10 seconds. The interior motion sensor is not active.

▷ The indicator lamp goes out after unlocking:
The vehicle has not been tampered with.

▷ If the indicator lamp flashes after unlocking until the remote control is inserted in the ignition, but for no longer than approx. 5 minutes:
An alarm has been triggered.

    See also:

    General information
    Moving parts need to be broken in to adjust to each other. The following instructions will help achieve a long vehicle life and good economy. ...

    Functional requirement
    ▷ To lock the vehicle, the remote control must be located outside of the vehicle.. ▷ The next unlocking and locking cycle is not possible until after approx. 2 seconds.. ▷ The e ...

    Display on the Control Display
    Switching on the backup camera via iDrive With Top View switched on: "Rear view camera" The backup camera image is displayed. The setting is stored for the remote control currently ...