Incoming call

Receiving calls

If the number of the caller is stored in the phone book and is transmitted by the network, the name of the contact is displayed. Otherwise, only the phone number is displayed.

If more than one phone number is assigned to a contact, only the name of the contact is displayed.

For calls on the additional telephone, the number is only displayed if it is transmitted by the network.

An incoming call to the additional telephone is automatically rejected if there is an active call on the other telephone.

Accepting a call

Via iDrive

"Accept" "Accept"

Via the button on the steering wheel

Via the button on the steering wheel

Press the button. Press the button.

Via the instrument cluster*

"Accept"

Rejecting a call

Via iDrive

"Reject" "Reject"

Via the instrument cluster

"Reject"

Ending a call

Via iDrive

"End call" "End call"

Via the button on the steering wheel

Press the button. Press the button.

Via the instrument cluster

"End call"

    See also:

    Functional requirement
    ▷ To lock the vehicle, the remote control must be located outside of the vehicle.. ▷ The next unlocking and locking cycle is not possible until after approx. 2 seconds.. ▷ The e ...

    View of an opened menu
    When a menu is opened, it generally opens with the panel that was last selected in that menu. To display the first panel of a menu: ► Move the controller to the left repeatedly until the f ...

    The concept
    Two radar sensors below the rear bumper monitor the area behind and next to the vehicle at speeds above approx. 30 mph/50 km/h. The system indicates whether there are vehicles in the blind sp ...