Adjusting the volume

Turn the knob until the desired volume is selected. The setting is stored for the remote control currently in use.

The vehicle automatically adjusts the volume of the microphone on the telephone and the volume of the called party. Depending on the mobile phone, the volumes may need to be adjusted. The settings can only be created during a call and must be adjusted separately for each telephone. The settings are deleted when the telephone is unpaired.

1. "Settings"

2. "Tone"

3. "Volume settings"

4. Select the desired setting: "Microphone" or "Loudspeak."

5. To adjust: turn the controller.

6. To store: press the controller.

    See also:

    Display on the Control Display
    Switching on the backup camera via the iDrive With PDC activated: "Rear view camera" The backup camera image is displayed. The setting is stored for the remote control currently in ...

    Tail lamps, bulb replacement
    At a glance 1 Turn signal 2 Backup lamp 3 Inside brake lamp 4 Tail lamp 5 Tail lamp/brake light Turn signal, tail lamp and brake lamp Follow the general instructions on lamps and bulbs. 21- ...

    Malfunction
    The yellow warning lamp flashes and then lights up continuously. A Check Control message is displayed. No flat tire can be detected. Display in the following situations: A wheel without T ...