Settings for the map view

The settings are stored for the remote control currently in use.

1. "Navigation"

2. "Map"

3. Open "Options".

4. "Settings"

Set the map view.

  • "Day/night mode"
    Select and create the necessary settings depending on the light conditions. "Traffic conditions/gray map" active: the setting is disregarded.
  • "Satellite images"
    Depending on availability and resolution, satellite images* are displayed in a scale of approx. 1 mile to 600 miles/2 km to 1,000 km.
  • "Perspective view in 3D"
    Prominent areas that are contained in the navigation data are displayed on the map in 3D.
  • "Traffic conditions/gray map"
    The map is optimized for displaying traffic bulletins. Symbols for the special destinations are no longer displayed.
    See also:

    Connecting electrical devices
    Sockets The lighter socket can be used as a socket for electrical equipment while the engine is running or when the ignition is switched on. The total load of all sockets must not exceed 140 Wa ...

    Following part replacement
    The same breaking in procedures should be observed if any of the components mentioned above have to be renewed in the course of the vehicle's operating life. ...

    Powertrain: The essence of BMW EfficientDynamics.
    The new BMW 5-Series will be offered in the United States with a choice of three gasoline engines. At its introduction, the new 5-Series will be available as a 535i and 550i. The 528i and xDrive a ...