Display
Night Vision with pedestrian detection is not available on the rear screen*.
Settings via iDrive
With Night Vision switched on:
1. Activate Night Vision with pedestrian detection.
2. Press the controller.
3. Open the desired menu item.
▷ 
"Brightness"
▷ 
"Contrast"
▷ 
"Pedestrian detection"
The settings are stored for the remote control currently in use.
See also:
Switching off automatically
The system switches off and the LED goes out:
After approx. 33 ft/10 m when driving forward.
Above approx. 9 mph/15 km/h when driving
forward.
Switch on the system again if necessary. ...
Glove compartment
Opening
Pull the handle.
The light in the glove compartment comes on.
To prevent injury in the event of an accident
while the vehicle is being driven, close the glove compartment immediately a ...
Message when the system was not
reset
A Check Control message is displayed.
The system detected a wheel change but was
not reset.
Warnings regarding the current tire inflation
pressure are not reliable.
Check the tire inflation pre ...