Signal tones

When approaching an object, an intermittent tone is sounded that indicates the position of the object. For example, if an object is detected to the left rear of the vehicle, a signal tone sounds from the left rear speaker.

The shorter the distance to the object becomes, the shorter the intervals.

If the distance to a detected object is less than approx. 12 in/30 cm, a continuous tone is sounded.

If objects are located both in front of and behind the vehicle, an alternating continuous signal is sounded.

The intermittent tone is interrupted after approx. 3 seconds:

  • If the vehicle stops in front of an object that is detected by only one of the corner sensors.
  • If moving parallel to a wall.

The signal tone is switched off:

  • When the vehicle moves away from an object by more than approx. 4 in/10 cm.
  • When transmission position P is engaged.

Volume

You can set the volume of the PDC signal tone.

The setting is stored for the remote control currently in use.

    See also:

    Avoid high engine speeds
    Use 1st gear to get the vehicle in motion. Beginning with 2nd gear, accelerate rapidly. When accelerating, shift up before reaching high engine speeds. When you reach the desired speed, shift i ...

    Measurement
    Measurements are made by ultrasound sensors in the bumpers. The range is approx. 6 ft/2 m. An acoustic warning is first given: ▷ By the front sensors and two rear corner sensors at approx ...

    Hiding Check Control messages
    Press the computer button on the turn signal lever. Some Check Control messages are displayed continuously and are not cleared until the malfunction is eliminated. If several malfunct ...