DSC OFF

Driving stability is limited during acceleration and when driving in bends.

Stabilizing interventions by the Integral Active Steering* system are only performed by the rear axle steering.

To increase vehicle stability, activate DSC again as soon as possible.

Activating DSC OFF

not longer Press and hold the button, but not longer than approx. 10 seconds, until the indicator lamp for the DSC lights up in the instrument cluster and DSC OFF is displayed in the tachometer. The DSC system is switched off.

Deactivating DSC OFF

DSC OFF and the DSC indicator lamp Press the button. DSC OFF and the DSC indicator lamp go out.

Indicator/warning lamps

When DSC OFF is activated, DSC OFF is displayed in the tachometer.

OFF The indicator lamp lights up: DSC OFF is activated.

    See also:

    Signaling a turn
    Press the lever beyond the resistance point. To switch off manually, press the lever to the resistance point. Unusually rapid flashing of the indicator lamp indicates that a turn signal bulb has ...

    Tire inflation pressures at max. speeds above 100 mph/160 km/h
    Speeds above 100 mph/160 km/h In order to drive at maximum speeds in excess of 100 mph/160 km/h, please observe, and, if necessary, adjust tire pressures for speeds exceeding 100 mph/160 km/h ...

    Vehicle equipment
    All standard, country-specific and optional equipment that is offered in the model series is described in this chapter. Therefore, equipment is also described that is not available in a vehicle, ...