Fold-out position of the wipers

Required when changing the wiper blades or under frosty conditions, for example.

1. Switch off the ignition.

2. Under frosty conditions, ensure that the wiper blades are not frozen onto the windshield.

3. Press the wiper lever up beyond the point of resistance and hold it for approx. 3 seconds, until the wiper remains in a nearly vertical position.

After the wipers are folded back down, the wiper system must be reactivated.

Before switching the ignition on, fold the Fold the wipers back down

Before switching the ignition on, fold the wipers back down to the windshield; otherwise, the wipers may become damaged when they are switched on.

1. Switch on the ignition.

2. Press the wiper levers down. The wipers move to their resting position and are ready for operation.

    See also:

    Radar sensor
    Position Position The radar sensor is integrated in the bumper. Dirty or covered sensor A dirty or covered sensor may hinder the detection of vehicles. ▷ If necessary, clean the radar s ...

    Service and Warranty Information Booklet for US models and Warranty and Service Guide Booklet for Canadian models
    Please consult your Service and Warranty Information Booklet for US models and Warranty and Service Guide Booklet for Canadian models for additional information on service requirements. Mainten ...

    After washing the vehicle
    After washing the vehicle, apply the brakes briefly to dry them; otherwise, braking action can be reduced and corrosion of the brake discs can occur. ...