After a power failure

after a power failure Only put the parking brake into operation after a power failure

The parking brake should only be put into operation again if it was manually released due to an interruption in the supply of electrical power. Otherwise, it cannot be ensured that the parking brake will function properly.

Putting the parking brake into operation

1. Switch on the ignition.

2. brake is depressed Press the switch while the brake is depressed or transmission position P is engaged.

It may take several seconds for the brake to be put into operation. Any sounds associated with this are normal.

instrument The indicator lamp in the instrument cluster goes out as soon as the parking brake is ready for operation.

Canadian Lower lamp: indicator lamp in Canadian models.

    See also:

    Initialization
    The initialization process adopts the set inflation tire pressures as reference values for the detection of a flat tire. Initialization is started by confirming the inflation pressures. Do not ...

    Snow chains
    Fine-link snow chains Only certain types of fine-link snow chains have been tested by the manufacturer of your vehicle, classified as road-safe and recommended. Consult your service center for m ...

    Transporting the vehicle
    Note Your vehicle is not permitted to be towed. Therefore, contact a service center in the event of a breakdown. Do not have the vehicle towed Have your vehicle transported on a loading plat ...