Manual release

The parking brake can be released manually in the event of a power failure or electrical fault.

against rolling Before releasing, secure the vehicle against rolling

Before releasing the parking brake manually, and whenever you park the vehicle with the parking brake released, ensure that position P of the automatic transmission is engaged.

Secure the vehicle in a manner appropriate to the inclination of the road, e.g., with a wheel chock; otherwise, there is the danger of the vehicle rolling.

Unlocking

1. Remove the release tool from the tool kit.

2. Raise the floor panel in the cargo area.

2. Raise the floor panel in the cargo area.

3. Take out the floor trim in the cargo area, removing

3. Take out the floor trim in the cargo area, removing the screws with the release tool, arrows.

4. Place the release tool on the release point,

4. Place the release tool on the release point, arrow.

5. Forcefully pull the release tool up against the

5. Forcefully pull the release tool up against the resistance until you notice a marked increase in the resistance and the parking brake releases audibly.

Have the malfunction corrected

If the parking brake has been released Have the malfunction corrected

If the parking brake has been released manually in response to a malfunction, only technicians can return it to operation.

Have the malfunction corrected by your service center.

    See also:

    Last destinations
    At a glance The destinations previously entered are stored automatically. The destinations can be called up and used as a destination for destination guidance. Calling up the last destination ...

    Hydroplaning
    On wet or slushy roads, a wedge of water can form between the tires and road surface. This phenomenon is referred to as hydroplaning. It is characterized by a partial or complete loss of contact ...

    End of warning
    The warning ends: Automatically after approx. 3 seconds. When returning to your own lane. When braking hard. When using the turn signal. ...