Initializing after a power failure
After a power failure during the opening or closing process, the roof can only be operated to a limited extent.
Initializing the system
The system can be initialized when the vehicle is stationary and the engine is running.
Danger of pinching
Monitor the closing process and make sure that the closing path of the glass sunroof is clear; otherwise, injuries may result.
Press the switch up and hold it until the initialization is complete:
- Initialization begins within 15 seconds and is completed when the sunroof and sliding visor are completely closed.
- The roof closes without pinch protection.
See also:
High-beam Assistant
The concept
When the low beams are switched on, this system
automatically switches the high beams on
and off or suppresses the light in the areas that
blind oncoming traffic. The procedure is cont ...
Using the door lock
General information
Locking from the outside
Do not lock the vehicle from the outside if
there are people in it, as the vehicle cannot be
unlocked from inside without special knowledge.
The ...
Hood
Releasing
Pull the lever.
Opening
To avoid damage, make sure that the wiper arms
are against the windshield before you open the engine compartment. Do not open the
engine hood before the engin ...