Following the initial pairing

► The mobile phone is detected/connected in the vehicle within a short period of time when the engine is running or the ignition is switched on.
► The phone book entries of the telephone stored on the SIM card or mobile phone are transmitted to the vehicle after detection, depending on the mobile phone.
► Four mobile phones can be paired.
► Specific settings may be necessary in some mobile phones, e.g., authorization or a secure connection; refer to the mobile phone operating instructions.

    See also:

    Preparation
    1. Check whether the battery of the other vehicle has a voltage of 12 volts and approximately the same capacitance in Ah. This information can be found on the battery. 2. Switch off the engine ...

    iDrive in the rear
    Operation is the same as for the iDrive in the front. To adjust the volume: turn, arrows 1. To activate the controller and switch between the screens: press the buttons, arrows 2. ...

    Initialization
    The initialization process adopts the set inflation tire pressures as reference values for the detection of a flat tire. Initialization is started by confirming the inflation pressures. Do not ...