Lane departure warning

The concept

Starting at a specific speed, this system alerts you when the vehicle on streets with lane markings is about to leave the lane. Depending on the country-specific version of the vehicle, the speed is between 35 mph/55 km/h and 45 mph/70 km/h. When switching on the system below this speed, a message appears in the instrument cluster.

The steering wheel begins vibrating gently in the event of warnings. The time of the warning may vary depending on the current driving situation.

The system does not provide a warning if the turn signal is set before leaving the lane.

Switching on/off

Press the button.

Press the button.

► On: the LED lights up.
► Off: the LED goes out.

The state is stored for the remote control currently in use.

Display

► Lines, arrow 1: the system is activated.

► Lines, arrow 1: the system is activated.
► Arrows, arrow 2: at least one lane marking was detected and warnings can be issued.

Issued warning

If you leave the lane and if a lane marking has been detected, the steering wheel begins vibrating.

If the turn signal is set before changing the lane, a warning is not issued.

End of warning

The warning ends:

► Automatically after approx. 3 seconds.
► When returning to your own lane.
► When braking hard.
► When using the turn signal.

System limits

The system cannot serve as a substitute Personal responsibility
The system cannot serve as a substitute for the driver's personal judgment of the course of the road and the traffic situation.
In the event of a warning, do not jerk the steering wheel, as you may lose control of the vehicle.◄

The system may not be fully functional in the following situations:

► In heavy fog, rain or snowfall.
► In the event of worn, poorly visible, merging, diverging, or multiple lane markings such as in construction areas.
► When lane markings are covered in snow, ice, dirt or water.
► In tight curves or on narrow lanes.
► When the lane markings are covered by objects.
► When driving very close to the vehicle in front of you.
► When driving toward bright lights.
► When the windshield behind the interior rearview mirror is fogged over, dirty or covered with stickers, etc.
► During calibration of the camera immediately after vehicle shipment.

Camera

The camera is located near the base of the mirror.

The camera is located near the base of the mirror.

Keep windshield clean and clear in the area in front of the interior rear view mirror.

    See also:

    The concept
    The Check Control system monitors functions in the vehicle and notifies you of malfunctions in the monitored systems. A Check Control message is displayed as a combination of indicator or warni ...

    Lane information
    On multi-lane roads, the recommended lanes are marked in the arrow view by a triangle. ▷ Solid triangle: best lane. ▷ Empty triangle: possible lane. However, another lane change may ...

    Speed limit
    You can enter a speed, and a Check Control message will indicate when you reach this speed. This enables you, for example, to receive warnings if you exceed a speed limit in an urban area. You ar ...