Transmission positions

D Drive, automatic position

Position for normal vehicle operation. All forward gears are available.

R is Reverse

Select only when the vehicle is stationary.

N is Neutral

Use in automatic car washes, for example. The vehicle can roll.

When the ignition is switched off, refer to page 59, position P is engaged automatically.

P Park

Select only when the vehicle is stationary. The drive wheels are blocked.

P is engaged automatically:

► After the engine is switched off, if the car is in radio ready state, or if the ignition is switched off, and if position R or D is engaged.
► With the ignition is off, if position N is engaged.
► If the safety belt is unbuckled, the driver's door is opened, and the brake pedal is not pressed while the vehicle is stationary and transmission position R or D is engaged.

Before exiting the vehicle, make sure that position P of the automatic transmission is engaged.

Otherwise, the vehicle may begin to roll.

Kickdown

Kickdown is used to achieve maximum driving performance. Press on the gas pedal beyond the resistance point at the full throttle position.

    See also:

    Switching the high beams on and off manually
    Switching the high beams on and off manually ▷ High beams on, arrow 1. ▷ High beams off/headlamp flasher, arrow 2. The High-beam Assistant can be switched off when manually adjustin ...

    Tow fitting
    The screw-in tow fitting should always be carried in the vehicle. It can be screwed in at the front or rear of the BMW. It is located in the container on the inside of the trunk lid. Tow fit ...

    Coolant temperature
    A warning lamp will come on if the coolant, and therefore the engine, becomes too hot. In addition, a message will appear on the Control Display. Check the coolant level ...