Washing in automatic car washes
Give preference to cloth car washes or those that use soft brushes in order to avoid paint damage.
Notes
Note the following:
▷ Make sure that the wheels and tires are not damaged by the transport mechanisms.
▷ Fold in the exterior mirrors; otherwise, they may be damaged, depending on the width of the vehicle.
▷ Deactivate the rain sensor, to avoid unintentional wiper activation.
▷ In some cases, an unintentional alarm can be triggered by the interior motion sensor of the alarm system. Follow the instructions on avoiding an unintentional alarm
Guide rails in car washes
Avoid car washes with guide rails higher
than 4 in/10 cm; otherwise, the vehicle body
could be damaged.◀
Before driving into a car wash
In order to ensure that the vehicle can roll in a car wash, take the following steps:
Manual transmission:
1. Release the parking brake.
2. Drive into the car wash.
3. Shift to neutral.
4. Switch the engine off.
5. Switch on the ignition.
Automatic transmission:
1. Release the parking brake, and deactivate Automatic Hold.
2. Drive into the car wash.
3. Depress the brake pedal as needed.
4. Engage transmission position N.
5. Switch the engine off. In this way, the ignition
remains switched on, and a Check-Control
message is displayed.
Transmission position P with the ignition
off
When the ignition is switched off, position P
is engaged automatically. When in an automatic
car wash, for example, ensure that the
ignition is not switched off accidentally.◀
The vehicle cannot be locked from the outside when in transmission position N.
A signal is sounded when an attempt is made to lock the vehicle.
Transmission position
Transmission position P is engaged automatically:
▷ When the ignition is switched off.
▷ After approx. 15 minutes.
See also:
Tire tread
Summer tires
Do not drive with a tire tread depth of less than
0.12 in/3 mm.
There is an increased danger of hydroplaning if
the tread depth is less than 0.12 in/3 mm.
Winter tires
Do not driv ...
Switching on automatically
Select transmission position R with the engine
running. ...
Initiating an Emergency Request
1. Press the cover briefly to open it.
2. Press the SOS button until the LED in the
button lights up.
The LED lights up: an Emergency Request
was initiated.
If the situation allows, wait ...