Lamp and bulb replacement

General information

Lamps and bulbs make an essential contribution to vehicle safety.

The manufacturer of the vehicle recommends that you entrust corresponding procedures to the service center if you are unfamiliar with them or they are not described here.

You can obtain a selection of replacement bulbs at the service center.

Only change bulbs when they are cool; Danger of burns
Only change bulbs when they are cool; otherwise, there is the danger of getting burned.◀

When working on the lighting system, you Working on the lighting system
When working on the lighting system, you should always switch off the lights affected to prevent short circuits.

To avoid possible injury or equipment damage when replacing bulbs, observe any instructions provided by the bulb manufacturer.◀

xenon headlamps Do not perform work/bulb replacement on
xenon headlamps Have any work on the xenon lighting system, including bulb replacement, performed only by a service center. Due to the high voltage present in the system, there is the danger of fatal injuries if work is carried out improperly.◀

Do not touch the glass of new bulbs with Do not touch the bulbs
Do not touch the glass of new bulbs with your bare hands, as even minute amounts of contamination will burn into the bulb's surface and reduce its service life.

Use a clean tissue, cloth or something similar, or hold the bulb by its base.◀

Light-emitting diodes (LEDs)

Light-emitting diodes installed behind a cover serve as the light source for controls, display elements and other equipment.

These light-emitting diodes, which are related to conventional lasers, are officially designated as Class 1 light-emitting diodes.

Do not remove the covers, and never stare Do not remove the covers
Do not remove the covers, and never stare into the unfiltered light for several hours; otherwise, irritation of the retina could result.◀

Headlamp glass

Condensation can form on the inside of the external lamps in cool or humid weather. When driving with the light switched on, the condensation evaporates after a short time. The headlamp glasses do not need to be changed.

If the headlamps do not dim despite driving with the light switched on, increasing humidity forms, e. g. water droplets in the light, have the service center check this.

See also:

General information
Additional information can be displayed on the right side of the split screen, e.g., information from the computer. In the divided screen view, the so-called split screen, this information rema ...

Following the initial pairing
The mobile phone is detected/connected in the vehicle within a short period of time when the engine is running or the ignition is switched on. The phone book entries of the telephone ...

Hiding Check Control messages
Hiding Check Control messages Press the computer button on the turn signal lever. ▷ Some Check Control messages are displayed continuously and are not cleared until the malfunction is ...