Reassigning individual programs

1. Switch on the ignition.
2. Hold the hand-held transmitter a distance of approx. 1 to 3 in/2.5 to 8 cm from the memory buttons.
The required distance depends on the manual transmitter.
3. Hold down the memory button of the integrated universal remote control.
4. If the LED flashes slowly after approx.

20 seconds, press the transmit button on the hand-held transmitter.
5. Release both buttons when the LED flashes rapidly.
If the LED does not flash rapidly after approx.
60 seconds, change the distance and repeat the step.
Canada: if the LED is not flashing rapidly after approx. 60 seconds, change the distance and repeat the step, or, if the programming was interrupted by the hand-held transmitter, hold down the memory button and press and release the button on the hand-held transmitter again for 2 seconds.

    See also:

    Setting the voice dialog
    You can set whether the system should use the standard dialog or a shorter version. In the shorter variant of the voice dialog, the announcements from the system are issued in an abbreviated fo ...

    Environmental conditions
    ► Say the commands, numbers, and letters smoothly and with normal volume, emphasis, and speed. ► Always say commands in the language of the voice activation system. ► When selec ...

    Clean the windshield, headlamps
    Clean the windshield, headlamps Pull the lever. The system sprays washer fluid on the windshield and activates the wipers briefly. In addition, the headlamps are cleaned at regular interval ...