The concept
This system can replace up to three different hand-held transmitters for various types of remote- controlled equipment, such as garage doors or lighting systems.
The hand-held transmitter signal can be programmed on one of the three memory buttons.
The corresponding device can then be operated using the programmed memory button.
The LED indicates that a signal is being transmitted.
When selling the vehicle, delete the stored programs for security reasons.
During programming
During programming and before activating
a device using the integrated universal remote
control, ensure that there are no people,
animals, or objects in the range of movement of
the remote-controlled device; otherwise, there
is a risk of injury or damage.
Also follow the safety instructions of the handheld transmitter.◀
See also:
Initialization
The initialization process adopts the set inflation
tire pressures as reference values for the detection
of a flat tire. Initialization is started by confirming
the inflation pressures.
Do not ...
Buckling the belt
Make sure you hear the latch plate engage in the
belt buckle.
Tensioning the safety belt
automatically
After the belt is buckled and the door is closed,
the belt is tightened once automatica ...
Programming
General information
1. Switch on the ignition.
2. Initial setup:
Press and hold the left and right button on
the interior rearview mirror simultaneously
for approximately 20 seconds until the L ...