Setting
Pull the switch.
The LED lights up.
The indicator lamp lights up in
red. The
parking brake is set.
Lower lamp: indicator lamp in
Canadian
models
Set the parking brake and further secure
the vehicle as required
Set the parking brake firmly when parking; otherwise,
the vehicle could roll. On steep upward
and downward inclines, further secure the vehicle,
for example, by turning the steering wheel in
the direction of the curb. ◀
While driving
Use while driving serves as an emergency braking function:
Pull the switch and hold it. The vehicle brakes hard while the button is being pulled.
The indicator lamp lights up in
red, a signal
sounds and the brake lamps light up.
Lower lamp: indicator lamp in
Canadian
models
If the vehicle is braked to a speed of approx.
2 mph/3 km/h, the parking brake remains set.
See also:
Parking lamps/low beams,headlamp control
General information
Switch position: 0, ,
If the driver door is opened with the ignition
switched off, the exterior lighting is automatically
switched off at these switch settings.
Parking lamps
...
Replacing the battery
Replacing the battery
1. Take the integrated key out of the remote
control.
2. Push in the catch with the key, arrow 1.
3. Remove the cover of the battery compartment;
see arrow 2.
4. Insert ...
Switching on/off
Press the button.
On: the LED lights up.
Off: the LED goes out.
The system can issue warnings at speeds above
approx. 30 mph/50 km/h.
The state is stored for the remote control currentl ...