Storing
1. Switch on the ignition.
2. Set the desired position.
3. 
Press the button. The LED in the
button lights up.
4. Press the desired button 1 or 2. The LED
goes out.
If the M button is pressed accidentally:
Press the button again.
The LED goes out.
See also:
Visual warning
The approach to an object can be shown on the
Control Display.
When the distance to an object is small, the PDC
display correspondingly shows a red bar in front
of the vehicle.
The display a ...
Putting into operation after a power failure
Putting the parking brake into operation
The parking brake should only be put into
operation again if it was manually released due
to an interruption in the supply of electrical
power. Otherw ...
Controls
At a glance
1 System on/off, interrupt
2 Resume speed
3 Store speed
4 Store, maintain/change speed
Switching on
Press the button on the steering
wheel.
The marking in the speedometer is ...