Safety belts

Seats with safety belt

The vehicle has five seats, each of which is equipped with a safety belt.

Notes

Always make sure that safety belts are being worn by all occupants before driving away.

Although airbags enhance safety by providing added protection, they are not a substitute for safety belts.

▷ The shoulder strap's anchorage point will be correct for adult seat occupants of every build if the seat is correctly adjusted.
▷ The two outer safety belt buckles, integrated into the rear seat, are for passengers sitting on the left and right.
▷ The center rear seat belt buckle marked with the letters CENTER is solely intended for the center passenger.

Never allow more than one person to wear One person per safety belt
Never allow more than one person to wear a single safety belt. Never allow infants or small children to ride on a passenger's lap.◀

Lay the belt, without twisting, snugly Putting on the belt
Lay the belt, without twisting, snugly across the lap and shoulders, as close to the body as possible. Make sure that the belt lies low around the hips in the lap area and does not press on the abdomen. Otherwise, the belt can slip over the hips in the lap area in a frontal impact and injure the abdomen.

The safety belt must not lie across the neck, rub on sharp edges, be routed over solid or breakable objects, or be pinched.◀

Avoid wearing clothing that prevents the Reduction of restraining effect
Avoid wearing clothing that prevents the belt from fitting properly, and pull the shoulder belt periodically to readjust the tension across your lap; otherwise, the retention effect of the safety belt may be reduced.◀

See also:

Tail lamps, bulb replacement
At a glance 1 Turn signal 2 Backup lamp 3 Inside brake lamp* 4 Tail lamp 5 Outside brake lamp 6 Rear reflector* Turn signal, brake, tail, and license plate lamps Follow the general instruc ...

Opening and closing: From inside
This button serves to unlock or lock doors and the trunk lid, but does not activate the anti-theft system. The fuel filler flap remains unlocked. Automatic lockingYou can also set the situations ...

Reprogramming individual buttons
1. Switch on the ignition. 2. Press and hold the interior rearview mirror button to be programmed. 3. As soon as the interior rearview mirror LED starts flashing slowly, hold the hand-held transm ...