Avoiding unintentional alarms

The tilt alarm sensor and interior motion sensor can be switched off together, such as in the following situations:

▷ In automatic car washes.
▷ In duplex garages.
▷ During transport on car-carrying trains, at sea or on a trailer.
▷ When animals are to remain in the vehicle.

Switching off the tilt alarm sensor and interior motion sensor

again Press the remote control button again within 10 seconds as soon as the vehicle is locked.

The indicator lamp lights up for approx. 2 seconds and then continues to flash.

The tilt alarm sensor and interior motion sensor are switched off until the vehicle is locked again.

    See also:

    Lamp and bulb replacement
    General information Lamps and bulbs make an essential contribution to vehicle safety. The manufacturer of the vehicle recommends that you entrust corresponding procedures to the service center ...

    For US owners only
    The transmitter and receiver units comply with part 15 of the FCC/Federal Communication Commission regulations. Operation is governed by the following: FCC ID: ▷ NBG009014A. Compliance ...

    Changing, maintaining, and storing the speed
    The rocker switch can be pressed while the system is interrupted to maintain and store the current speed. DSC Dynamic Stability Control is switched on, if necessary. Adapting the desired speed ...