Connecting the cables
1. Open the cover of the BMW starting aid terminal.
2. Attach one terminal clamp of the positive jumper cable to the positive terminal of the battery, or to the corresponding starting aid terminal of the assisting vehicle.
3. Attach the other end of the cable to the positive terminal of the battery, or to the corresponding starting aid terminal of the vehicle to be started.
4. Attach one terminal clamp of the negative jumper cable to the negative terminal of the battery, or to the corresponding engine or body ground of assisting vehicle.
5. Attach the other end of the cable to the negative terminal of the battery, or to the corresponding engine or body ground of the vehicle to be started.
See also:
Messages after trip completion
Malfunctions indicated during a trip are displayed
again after the ignition is switched off. ...
Maximum cooling
Press the button.
The system is set to the lowest temperature,
maximum air volume and recirculatedair
mode.
Air flows out of the vents for the upper body region.
Open them for this purpose.
...
Coolant temperature
A warning lamp will come on if the coolant, and
therefore the engine, becomes too hot. In addition,
a message will appear on the Control Display.
Check the coolant level ...