What to do if...
▷ The current transmission position cannot be displayed?
The vehicle is located in an unrecognized region, is in a poor reception area, or the system is currently determining the position.
Reception is usually best when you have an unobstructed view of the sky.
▷ The destination without street information is not used for route guidance?
When city has been input, no downtown can be determined.
Input any street in the selected city and start destination guidance.
▷ The destination is not used for route guidance?
The destination data is not contained in the navigation data. Select a destination that is as close as possible to the original.
▷ Letters for destination input cannot be selected?
The stored data do not contain the data of the destination.
Select a goal that is as close as possible to the original.
▷ Is the map displayed in shades of gray?
"Traffic conditions/gray map" Active: indication on the control display is switched to shades of gray. This enables a better view of the traffic bulletins.
▷ Spoken instructions are no longer output during route guidance in front of intersections?
The area has not yet been fully recorded, or you have left the recommended route and the system requires a few seconds to calculate a new route suggestion.
See also:
Split screen map view
The map view can be selected for the split
screen independently from the main screen.
1. Open "Options".
2. "Split screen"
3. Move the controller to the right repeatedly
unt ...
Checking the oil level
The concept
The oil level is monitored electronically and displayed
on the Control Display.
Requirements
The engine must be running and warm after
the vehicle has been driven for at least
...
At a glance
General infor
► Display the traffic bulletins from radio stations
that broadcast the TI Traffic Information
of a traffic information service. Information
on traffic obstructions and hazards ...