Display on the Control Display
Switching on the backup camera via iDrive
With PDC activated:
"Rear view camera"
The backup camera image is displayed. The setting is stored for the remote control currently in use.
Brightness
With the backup camera switched on:
1. 
Select the symbol.
2. Turn the controller until the desired setting is reached and press the controller.
Contrast
With the backup camera switched on:
1. 
Select the symbol.
2. Turn the controller until the desired setting is reached and press the controller.
See also:
Changing batteries
Changing batteries
1. Press the detent and remove the cover.
2. Change the batteries. The type and installation
position are marked on the bottom of
the battery compartment.
3. Close the cove ...
Engine stop
The engine is switched off automatically during
a stop under the following conditions:
Manual transmission:
▷ Neutral is engaged and the clutch pedal is
not pressed.
▷ The driver's ...
Tail lamps, bulb replacement
At a glance
At a glance
1 Turn signal
2 Reversing lamp
3 Inside brake lamp
4 Tail lamps
5 Outside brake lamp
Bulb replacement, exterior tail lamps
General information
Follow the General ins ...