For US owners only

The transmitter and receiver units comply with part 15 of the FCC/Federal Communication Commission regulations. Operation is governed by the following:
FCC ID:
▷ NBG009014A.

Compliance statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
▷ This device may not cause harmful interference, and
▷ this device must accept any interference received, including interference that may cause undesired operation.

Any unauthorized modifications or changes to these devices could void the user's authority to operate this equipment.

    See also:

    Signal tones
    When approaching an object, an intermittent tone is sounded that indicates the position of the object. For example, if an object is detected to the left rear of the vehicle, a signal tone sounds ...

    Preparation
    1. Check whether the battery of the other vehicle has a voltage of 12 volts and approximately the same capacitance in Ah. This information can be found on the battery. 2. Switch off the engine ...

    Avoiding unintentional alarms
    The tilt alarm sensor and interior motion sensor can be switched off together, such as in the following situations: ▷ In automatic car washes. ▷ In duplex garages. ▷ During tr ...