Initialization

The initialization process adopts the set inflation tire pressures as reference values for the detection of a flat tire. Initialization is started by confirming the inflation pressures.

Do not initialize the system when driving with snow chains.

1. "Vehicle Info"
2. "Vehicle status"
3. 4. Start the engine - do not drive away. "Reset"
4. Start the engine - do not drive away.
5. Start the initialization with "Reset".
6. Drive away.

The initialization is completed while driving, which can be interrupted at any time.

The initialization automatically continues when driving resumes.

    See also:

    Notes
    > Reception may not be available in some situations, such as under certain environmental or topographic conditions. The satellite radio cannot influence this. > The signal may not be availabl ...

    Switching off automatically
    The system switches off and the LED goes out: ▷ After approx. 165 ft/50 m when driving forward. ▷ After approx. 22 mph/35 km/h when driving forward. Switch on the system again if nece ...

    With the Professional navigationsystem: map view for split screen
    The map view can be selected for the split screen independently from the main screen. 1. Open "Options". 2. "Split screen" 3. Move the controller to the right repeatedly until ...