Functional requirements

The system must have been initialized when the tire inflation pressure was correct; otherwise, reliable signaling of a flat tire is not ensured. Initialize the system after each correction of the tire inflation pressure and after every tire or wheel change.

    See also:

    Checking the pressure
    Only check the tire inflation pressure when the tires are cold. This means after driving no more than 1.25 miles/2 km or when the vehicle has been parked for at least 2 hours. When the tires are w ...

    General information
    BMW Assist provides you with certain services, e.g., transmission of the position data of your vehicle to the BMW Assist Response Center if an Emergency Request has been initiated. Many BMW Ass ...

    Buttons on the remote control
    Buttons on the remote control 1. Unlocking 2. Locking 3. Trunk lid 4. Panic mode, headlamp courtesy delay feature ...