Resetting the system

Reset the system after each correction of the tire inflation pressure and after every tire or wheel change.

1. "Vehicle Info"
2. "Vehicle status"
3. 4. Start the engine - do not drive away. "Reset"
4. Start the engine - do not drive away.
5. Reset the tire pressure using "Reset".
6. Drive away.

The tires are shown in gray and "Resetting TPM..." is displayed.

After driving for a few minutes, the set tire inflation pressures are applied as set values. The resetting process is completed automatically during driving. The tires are shown in green and "TPM active" is shown on the Control Display.

The trip can be interrupted at any time. If you drive away again, the process resumes automatically.

If a flat tire is detected during a reset, all tires are displayed in yellow.

    See also:

    Apps
    At a glance Certain software applications of a suitable cell phone can be integrated in the vehicle. These software applications are displayed on the Control Display. Operation can be performed ...

    Leather care
    Remove dust from the leather often, using a cloth or vacuum cleaner. Otherwise, particles of dust and road grime chafe in pores and folds, and lead to increased wear and premature degradation o ...

    System limits
    Top View cannot be used in the following situations: ▷ With a door open. ▷ With the trunk lid open. ▷ With an exterior mirror folded in. ▷ In poor light. A Check Control m ...